Hutto Roofing and Siding

Home / Uses / Hutto roofing and siding

Hutto Roofing Pros · Hutto, TX

Hutto Roofing and Siding: Where the Roof Meets the Wall

Hutto roofing and siding work belongs together more often than most homeowners expect, because the place a roof meets a wall is protected by flashing that sits behind the siding. Hutto Roofing Pros handles both, so the roof, the wall and the metal that joins them are planned as one job instead of two contractors pointing at each other.

The short answer

If hail or wind damaged both your roof and your siding, or if water is getting in where a roof meets a wall, do the work as one project. Properly replacing step and kickout flashing usually means lifting or removing the siding along that wall, so a combined roofing and siding job avoids paying twice and leaves one company responsible for the whole junction.

Aerial photo of a Hutto home where Hutto Roofing Pros handled roofing, with walls and roof lines meeting at flashed junctions
Where a roof meets a wall, the flashing hides behind the siding. That is why the two are worth doing together.
  • Since 2009Hutto Roofing Pros, roofing Hutto and Central Texas
  • Free inspectionsNo obligation, with photos you keep
  • Local office111 Co Op Blvd, Hutto, TX 78634
  • Homes & businessesResidential and commercial roofing
Why together

Why Hutto roofing and siding are one job more often than two

Look at any Hutto home where a lower roof runs into a second-story wall, or where a garage roof butts against the house. Along that line, small L-shaped pieces of metal called step flashing are woven in with each course of shingles and tucked up behind the siding. At the bottom of the wall, a kickout flashing turns water away from the wall and into the gutter. Neither can be properly replaced without lifting the siding above it.

When one contractor does the roof and another does the siding, that junction is where things go wrong. The roofer reuses old flashing because they cannot touch the wall. The siding crew nails through flashing they did not install. A leak shows up inside the wall months later, and each company blames the other. When Hutto Roofing Pros handles roofing and siding together, the flashing is replaced with the roof, the siding goes back over it correctly, and one company owns the result.

The junction

The flashing that ties a roof to the siding

These are the details Hutto Roofing Pros checks on every roof that meets a wall. Most leaks we trace at a roof-to-wall line come from one of them. If water is already coming in, read roof leaking? what to do first or see our Roof repair in Hutto TX page.

DetailWhat it doesWhat failure looks like
Step flashingLaps with each shingle course where a sloped roof meets a wallStains on the ceiling or wall below the roof-to-wall line
Kickout flashingDiverts water off the wall and into the gutter at the bottom of a roof edgeSwollen or stained siding and rotted trim at the corner below the roof
CounterflashingCovers the top of step flashing at brick, stone or stucco wallsCracked sealant and gaps at masonry where the roof meets it
Headwall flashingSeals the top of a roof that runs straight into a wallLeaks at a dormer face or where a porch roof meets the house
Drip edge and trimDirects water off the roof edge and protects fasciaRotted fascia, water stains behind the gutter
Storm damage

What Hutto hail and wind do to roofs and siding

Hutto sits on open Blackland Prairie with little tree cover, so storms hit the whole house, not just the roof. After hail, Hutto Roofing Pros inspects the roof and the walls together, because damage to both usually belongs on the same claim.

Vinyl siding

Hail can crack or punch holes in vinyl, especially on the side that faced the storm. Cracks let water reach the sheathing behind it.

Fiber cement siding

Holds up better than vinyl, but hail can chip edges and break paint, and cracked boards need replacing rather than patching.

Brick and stone fronts

Many Hutto homes pair a masonry front with siding on the sides and back. Masonry rarely fails in hail, but its counterflashing and sealant often do.

Shingles

Hail bruises shingles and knocks granules loose, usually without anything visible from the driveway.

Trim and fascia

Painted wood trim dents and splits, and wind lifts loose pieces, which lets water into the roof edge.

Gutters and downspouts

Dents are cosmetic until they change how water drains. Then they become a roof and siding problem at once.

More on documenting storm damage in our hail damage guide and storm damage insurance claims guide.

Order of work

How a Hutto roofing and siding project runs

Doing the work in the right order is most of what makes a combined job last.

1. Inspect both, togetherOne free inspection covers the roof, the walls and every junction between them, with photos of each.
2. One written scopeRoofing, siding and flashing listed line by line, so nothing falls between two contractors.
3. Roof and flashing firstThe roof goes on with new step, kickout and headwall flashing, with the siding opened along those walls.
4. Siding over the flashingSiding goes back on or is replaced over the new flashing, lapped so water always runs outward and down.
5. Trim, gutters, cleanupFascia, drip edge and gutters finished last, then a magnetic nail sweep and a walkthrough with you.
6. One company to callIf water ever shows up at that wall, there is one company responsible for the whole junction: our Hutto roofers.
Matching the house

Colors, HOAs and resale

Replacing a roof and siding together is the one time you can choose both colors at once, and in many Hutto neighborhoods the HOA approves both together too. Hutto Roofing Pros helps you pick combinations that suit the house and get HOA approval for the roof and siding before anything is ordered.

It also matters if you plan to sell. Buyers and inspectors notice mismatched patches of siding and a roof-to-wall line that has been sealed rather than flashed. A clean, documented roofing and siding job, with photos and an itemized scope, is an easy answer to an inspector's questions.

FAQ

Hutto roofing and siding questions

Does Hutto Roofing Pros do roofing and siding?

Yes. Hutto Roofing Pros handles roofing and siding together, including the flashing where the roof meets the wall, under one written scope.

Should I replace my roof and siding at the same time?

If both are damaged or near the end of their life, yes. Replacing step and kickout flashing properly usually means opening the siding along that wall, so doing both at once avoids paying for that work twice.

What is kickout flashing?

A piece of flashing at the bottom of a roof edge where it meets a wall. It turns water away from the wall and into the gutter. Missing kickout flashing is a common cause of rotted siding and trim.

Can hail damage siding?

Yes. Hail can crack vinyl siding and chip fiber cement, and it often damages trim and gutters at the same time as the roof. Inspect them together after a storm.

Does insurance cover roof and siding damage together?

If the same storm damaged both, they are often handled on the same claim. We document roof and siding damage with dated photos and a written scope; coverage decisions are between you and your carrier.

Which comes first, the roof or the siding?

The roof and its flashing first, then the siding over the new flashing, so water always laps outward and down.

Free roof inspection

Roofing and siding in Hutto, one company

Book a free inspection and Hutto Roofing Pros will look at your roof, your walls and every junction between them, then give you one written scope for the whole job. We have handled roofing in Hutto, Texas since 2009.

(512) 846-5048
Request your free inspection

OfficeHutto Roofing Pros
111 Co Op Blvd, Hutto, TX 78634

Phone(512) 846-5048

EmailHuttoroofingpros@gmail.com

ReviewsRead our Google reviews

Scroll to Top